How to replace headlight bulb for BMW X5 five-door SUV (F15)
Model years: 2013 - present
To ensure the safety of our own and others it's recommended to check whether the headlights are functioning well. Normally the fault of the headlight is a consequence of obsolete bulb, that will require closer attention to monitor the route at dusk times. Moreover your vehicle might become more difficult to notice for the other drivers. Whenever noticed, that the headlight does not light up, be sure you replace the bulb as soon as possible. When preparing to repair failed, be certain you have adequate bulb. If you noticed the other car with headlight bulb failure, please be responsible and tell the driver about it. The accident can be avoided.
The life-time of a bulb is limited. Sooner or later, it will burn out and will have to be replaced. Bulbs, made of high quality materials, tend to last longer. It's recommended to use well known brand replacement bulbs.
If bulb burns out right after installation, your vehicle might have a problem inside electrical system - have it checked by auto electrician.
Tip: Never touch glass housing of a halogen bulb with your fingers. Greasy spots might cause premature failure of the bulb. Handle the bulb by its base or use a piece of clean paper when installing.
BMW X5 headlight bulb list:
| Body type | Position | Bulb specs | Buy |
|---|---|---|---|
| Five-door SUV | High beam | Type: Halogen (H7) Voltage / Watts: 12V/55W | Amazon.com: $5.74pack of 1 $6.97pair Amazon.co.uk: £4.88pack of 1 £6.99pair |
| High beam | Type: Gas discharge (D1) Voltage / Watts: 12V/35W | Low beam | Type: Halogen (H7) Voltage / Watts: 12V/55W | Amazon.com: $5.74pack of 1 $6.97pair Amazon.co.uk: £4.88pack of 1 £6.99pair |
| Low beam | Type: Gas discharge (D1) Voltage / Watts: 12V/35W |
How to replace headlight bulb:
1.
Open the hood.
2.
Disconnect the headlight's wiring that supplies power to a bulb (usually no tools are needed, use you hands).
3.
Remove the bulb cover by turning it counter-clockwise till it can be easily pulled out.
4.
Swing open the bulb retention clip by gripping and pressing it using your fingers.
5.
Remove old headlight bulb.
6.
Insert the replacement bulb regarding the notches on both, the holder and the bulb itself. Do not touch the glass part of the bulb as it might fail prematurely.
7.
Attach bulb retention clip.
8.
Apply bulb cover back.
9.
Plug the wiring back in.
10.
Test if headlights work.
