Car battery replacement for BMW X1 five-door SUV (E84)
Model years: 2009 - present
Car battery is a major player inside vehicle's electrical system. In essence, it is a storage for electrical energy, which is provided for electric devices inside the car. Therefore, it's relevant to keep the battery in a properly operating condition. Sadly, car battery is not a permanent unit and will eventually become useless. More precisely, chemical reactions inside the battery will terminate and no electricity will be produced. Battery's life is limited to about 3 - 5 years, until it starts loosing the ability to hold a useful charge. This indicates, that installation of a new battery is advised. In some cases, battery's energy will be wasted, due to the soil concentrated on connection points. In time, battery terminals can get covered by a layer of white material (corrosion), which is a cause of weak connection contacts. This is the reason why the battery will lose the merit of being re-charged by alternator. Ultimately, it will get drained and no longer be able to provide electricity. Eliminating soil from cable and battery connections, might get the battery back to its normal operation and make it usable again. The battery may also get exhausted, if the car hasn't been driven for some time. In such case, battery recharge will likely restore its efficiency. To begin a recharge, you will need a battery charger.
Important! Some BMW X1 (E84) vehicles might be equipped with an IBS (Intelligent Battery Sensor) system. That means, newly replaced battery must be registered by your Service center. Avoiding battery registration might cause power management system failure, as well as incorrect readings on the display of the on-board computer.
BMW X1 battery location: luggage compartment (trunk) under floor carpet.
Recommended batteries for BMW X1:
* Note: if case more than one battery type is applicable for your model, compare parameters of the battery, currently installed on your vehicle, with parameters in the table below, before choosing the right one.
Body type | Model | Battery specs | Buy |
---|---|---|---|
Five-door SUV | X1 16d X1 16i X1 18d X1 18dX X1 18i X1 20d X1 20dX X1 20i X1 20iX X1 23dX X1 25dX X1 25iX X1 28iX | Capacity: 70Ah (AGM) Cold Cranking Amp: 760cca Dimensions: 278x175x190 mm | £139.99 (Amazon.co.uk) |
Capacity: 70Ah Cold Cranking Amp: 640cca Dimensions: 278x175x190 mm | £97.16 (Amazon.co.uk) | ||
Capacity: 80Ah (AGM) Cold Cranking Amp: 800cca Dimensions: 315x175x190 mm | £150.99 (Amazon.co.uk) | ||
Capacity: 80Ah Cold Cranking Amp: 720cca Dimensions: 315x175x175 mm | £72.99 (Amazon.co.uk) |
How to replace car battery:
1.
Before battery replacement, make sure:
- you wear sturdy gloves and safety goggles
- vehicle keys are out of ignition switch
2.
The following tools are usually enough for battery replacement procedure:
- 10 and 13 mm wrenches or sockets
- Flat-head and Phillips type screw drivers
3. BMW X1 battery is located in luggage compartment (trunk) under floor carpet.
4.
To start replacing battery, remove the old one by disconnecting the negative connection first. This will prevent accidental short-circuits between positive battery terminal and the body of the vehicle. Make sure the cable does not come into contact with battery terminals during battery replacement procedure. Negative battery terminal can be identified by minus (-) sign next to it (1):

5.
Remove brackets that hold the battery attached to the vehicle frame.
6.
Open positive terminal cover (1):

7.
Disconnect positive connector:

8.
If present, disconnect ventilation hose from the battery (1). Some vehicles utilize battery ventilation system to vent formed gasses (hydrogen) to the outside.

9.
Vacate battery compartment by lifting the old battery off (note, that the battery is heavy, incorrect lifting can result in back injuries):

10.
Do not remove plastic terminal caps from new battery, until it's placed in the battery compartment inside the vehicle.
11.
Place the new battery in.
12.
Connect ventilation hose.
13.
If necessary, clean battery cables from dirt or rust before connecting, to ensure excellent contact.
14.
Contrary to disconnecting the battery, connect cables, starting with positive terminal first.
15.
Re-attach brackets and make sure battery does not make any movements.
16.
Dispose the old battery only at authorized collecting point.